LA8 LA12X DSP power amplifier wired connection DSP software steps

Question

Accepted Answer

LA8 LA12X DSP power amplifier wired connection DSP software steps

Step 1: Insert the Ethernet cable

Step 2: Find the IPv4 address on the computer

For example, in the image below, the IPv4 address of this computer is 169.254.5.161

Remember this number, and enter the first 7 digits into the software.

Step 3: Enter the IP address into the software. The first 7 digits are the same as the computer. Pay attention to the last three digits, which can be any number between 0-250, but must be different from the last three digits of the computer.

Step 4: Enter the password: admin, and you will be successfully connected.

Other supplements:

If you need to set different input and output signals, there are two common settings below that can be saved to the computer.

Setting one: 2 input signals, 4 output signals.

Setting 2: 4 input signals, 4 output signals

Saving method: Preset - Save - Export - Import